Wifi card antenna replacement

Wireless tv transmitters Wireless Card Antenna Replacement wireless card A wireless network interface controller WNIC is a network card which connects to a radio-based computer network, unlike a regular network interface controller NIC which connects to a wire-based network such as token ring or ethernet.

Either of a pair of long, thin sensory appendages on the heads of insects, crustaceans, and some other arthropods. I never thought I'd say this, but I am becoming totally fascinated with grasshoppers! I didn't know they have retractable antennae until I saw it myself. Then again, you should probably consider invensting in something that's a bit more inexpensive if you really don't need this computer for daily use.

Thank you! You must log in or register to reply here. Components 2 Nov 21, Question Did I just short my motherboard? Help Components 6 Nov 17, Question PC is failing to boot, and displays a warning screen to replace my storage drives. Question Did I just short my motherboard?

Help Question PC is failing to boot, and displays a warning screen to replace my storage drives. Post thread. Question What is the motivation for building a PC exclusively for gaming when one can have gaming consoles for less than half of the price? Graphics Cards. Started by odibex Today at AM Replies: 5. Question Dead RX ? Keeps shutting down even at low to med usage. Started by jaybarillo Today at AM Replies: 8.

Question Undervolt cpu how? Started by zeekman Today at AM Replies: 3. Question Where is the cmos reset on this mb? Started by zeekman Today at AM Replies: 4. Latest posts. Build Advice New build or upgrade? Latest: vipergtrdj 1 minute ago. Latest: jasonf2 9 minutes ago. Power Supplies. Question Suddenly high data usage Latest: billg 9 minutes ago. Latest: dwd 9 minutes ago.

Moderators online. Use a plastic opening tool to pull up the four metal latches in the battery cavity that is located on the bottom of the laptop. Do not apply too much pressure. The latches can not be removed and will bend if forced. Use a plastic opening tool to lift the edge of the keyboard that is nearest to the screen.

Do not remove the keyboard completely. This can damage the ribbon cable connecting the underside of the keyboard to the laptop. Use a spudger tool to release the tabs on the ribbon cable ZIF connector that is attached to the underside of the keyboard. Depending on the model, the tabs on this ZIF connector will either flip up toward the display or push out toward the display.

Identify and disconnect touch pad ribbon cable which can be seen through a window at the bottom edge of the metal part of the top casing in these photos the connector shows blue. Two miniature LEDs will be exposed in the top edge of the bottom casing. Handle with caution to avoid damage. Detach each of the 5 plastic clips. Run a plastic opening tool along the underside of the top half. You will hear the 'clicks' of the clips coming undone. Completing this step according to the directions in step 4 reduces the potential for damage.

There may be only one of these screws, the one at bottom right. The upper position screw may already have been removed The 4th red circle from the left in step 4. Gently pull the hard drive to the left by the black plastic ribbon. Slowly lift the hard drive up on the left and then out.